| THE MOST COMMONLY ASKED QUESTIONS ABOUT Cover® |
MECHANICAL
- What is the Cover® seat made of?
- What is the Clean Cover® Wrap made of?
- Are Cover® parts under warranty?
- How often does the Clean Cover® Wrap need to be replaced?
- What is included in each box of Clean Cover® Wrap?
- What kind of power is used?
- If moisture builds up in the take-up side of the unit, where does it go?
- Does the Cover® replace the regular toilet seat?
- Does the Cover® seat lift like a conventional toilet seat?
- What if a technical problem is experienced?
- What material is the installation bracket made of?
- Can the Clean Cover® Wrap slip off the seat?
SANITARY PREVENTION SERVICE
- How long does it take to change a roll of Clean Cover® Wrap?
- What happens if the Cover® seat breaks down, or if the Clean Cover® Wrap runs out?
- What happens if someone discharges on the entire unit?
- How do I clean the Cover® seat?
- How will maintenance personnel know when the Clean Cover® Wrapis getting low?
- What happens if urine gets inside the Cover® seat?
- Will an acid-based cleaner harm the plastic?
- We have personnel available for the continuous cleaning of our restrooms. Why should we install Cover® seats?
GENERAL
- Will any germs contained on the surface of the used roll of Clean Cover® Wrap contaminate the user?
- Has the Cover® toilet seat been thoroughly tested prior to introduction to the U.S. market?
- Where can I obtain the Cover® seat and Clean Cover Wrap™?
MECHANICAL
- What is the Cover® seat made of?
A. ABS plastic-the same as telephones.
- What is the Clean Cover Wrap™ made of?
A. High density hygienic polyethylene, approximately one (1) mili (one-thousandth of an inch).
- Are Cover® parts under warranty?
A. Yes. Six (6) months against any manufacturing defects.
- How often does the Clean Cover Wrap™ need to be replaced?
A. The amount of Clean Cover Wrap™ used is totally dependent on the amount of traffic in the
establishment in which it is installed.
- What is included in each box of Clean Cover Wrap™?
A. Approximately 1,200 seatings of sanitary seat covers and take-up spools.
 Questions
- What kind of power is used?
A. 12 volt battery packs or 12 volt transformers.
- If moisture builds up in the take-up side of the unit, where does it go?
A. There is a tray located on the bottom side of the Clean Cover™ seat, which allows any excess liquid
to drain through the hole at the base of the tray, directly into the bowl.
- Does the Clean Cover™ replace the regular toilet seat?
A. Yes. The Clean Cover™ seat fits all standard toilets and is installed the same way as a conventional seat. Standard fittings are included with each unit.
- Does the Clean Cover™ seat lift like a conventional toilet seat?
A. Yes. It functions exactly the same way.
- What if a technical problem is experienced?
A. By following the instructions supplied with the Clean Cover™ seat, most technical problems can be easily
solved. If the problem is more difficult and not able to be resolved by your maintenance personnel, call
our service department.
- What material is the installation bracket made of?
A. Stainless steel.
- Can the Clean Cover Wrap™ slip off the seat?
A. No. It's in the form of a sleeve which fully encases the seat.
Questions
SANITARY PREVENTION SERVICE
- How long does it take to change a roll of Clean Cover Wrap™?
A. Less than a minute.
- What happens if the Clean Cover™ seat breaks down, or if the Clean Cover Wrap™ runs out?
A. The Clean Cover™ seat can be used as a regular toilet until the unit is repaired and/or a new roll of
Clean Cover Wrap™ is installed.
- What happens if someone discharges on the entire unit?
A. The chances of that are greatly reduced with Clean Cover™ because people will no longer hesitate to sit directly on the seat. If this should happen, however, clean the seat like any other conventional toilet seat.
- How do I clean the Clean Cover™ seat?
A. To clean the Clean Cover™ use a sponge or hand-towel dampened with household sanitizer, i.e., Lysol
or Pine-Sol cleaner.
- How will maintenance personnel know when the Clean Cover Wrap™ is getting low?
A. The LCD display will indicate how many seat covers are remaining on the roll.
Questions
- What happens if urine gets inside the Clean Cover™ seat?
A. Simply remove the cover, and clean the housing, using a household cleaner.
- Will an acid-based cleaner harm the plastic?
A. Yes. If a strong acid is continually used, it will harm the plastic surface. We recommend using a sponge or hand-towel dampened with household sanitizer, i.e., Lysol or Pine-Sol cleaner.
- We have personnel available for the continuous cleaning of our restrooms. Why should we install Clean Cover™ seats?
A. With Clean Cover™, the amount of personnel required to maintain restrooms can be drastically
reduced, or their priorities can be redirected to perform other duties. Even in those restrooms that
have a full time attendant, no on can guarantee a clean, sanitary seat every time. Now with the Clean
Cover™ seat it is possible...simply by waving your hand.
Questions
GENERAL
- Will any germs contained on the surface of the used roll of Clean Cover Wrap™ contaminate the user?
A. No, for the following reasons:
The used sleeve is wound up in a roll and any germs are confined in that roll. The used roll of
Clean Cover Wrap™ is enclosed in a separate chamber, to prevent the germs from migrating onto
the seat and/or the fresh roll of Clean Cover Wrap™.
- Has the Clean Cover™ toilet seat been thoroughly tested prior to introduction to the U.S. market?
A. Yes.
- Where can I obtain the Clean Cover™ Seat and Clean Cover Wrap™?
A. From your local Clean Cover™ Distributor, or call 1-800-260-0700.
Questions
|
|
|
